Contents
- 2 Package includes
- 3 INSTALLATION
- 4 MOUNTING FLOODLIGHT
- 5 FOR IN-GROUND INSTALLATION
- 6 ADJUSTING ANGLES
- 7 USAGE
- 8 CLEANING
- 9 TROUBLESHOOTING
- 10 TECHNICAL INFORMATION
- 11 Documents / Resources
- 11.1 Download manual
BELL+HOWELL MONSTER SOLAR ZAPPER - 2 in 1 Flood Lights Bug Zapper Manual
PARTS & FEATURES
- Adjustable Solar Panel
- Mounting Holes
- Mounting Plate
- 24 LED lights
- Motion Sensor
- ON/OFF Switch
- Zapper Grid
- 8 pcs UV 395nm
- Ground spike
- Stake
Package includes
- Monster Solar Zapper,
- 2 screws,
- 2 plastic anchors,
- 1 mounting plate,
- 1 ground spike,
- 1 stake.
HAZARDOUS VOLTAGE. Contact with energized components will result in electric shock. Use only for insects. Do not use water, liquids or sprays to clean.
Keep your hands/fingers away from the zapper grid.
NOT A TOY. KEEP AWAY FROM CHILDREN.
INSTALLATION
PLEASE READ THIS MANUAL CAREFULLY BEFORE USE AND KEEP IT FOR FUTURE USE.
- DO NOT use the Monster Solar Zapper in high traffic areas, if installing in the ground.
- When picking a place to install your Monster Solar Zapper, CHOOSE A LOCATION WITH MAXIMUM SUN EXPOSURE DURING THE DAY.
- Do not use the Solar Zapper to force the stake into the ground. First, insert the stake into the ground and then place floodlight over the stake.
- Avoid areas under trees or bushes as this will prevent a proper charge of the Solar Zapper.
- Do not install Solar Zapper near an existing outdoor light. The built-in sensor will prevent it from turning the flood lights on.
- When using the Solar Zapper in the fall, please note that due to fewer daylight hours, the batteries might not charge fully. This may affect the amount of time the Solar Zapper will be on.
- In case of heavy rain, we recommend to swivel each arm downwards to protect the zapper grid and avoid any damage to the unit. Do not touch the zapper grid.
MOUNTING FLOODLIGHT
- Choose a location with maximum sun exposure. Drill holes matching the pattern on the Mounting Plate and install plastic anchors (included). Attach the Mounting Plate using 2 screws (included).
- Align the mounting holes on the back of the Solar Zapper with the hooks on the Mounting Plate. Secure the unit.
FOR IN-GROUND INSTALLATION
- Insert Ground Spike into the Stake.
- Make sure the soil is softened. Insert Stake into the ground.
- Insert Solar Zapper over the Stake.
ADJUSTING ANGLES
- To adjust the angle of the Solar Panel, simply rotate it in a desired direction.
- Swivel each arm at maximum 60° angle to direct the zapper where needed. Do not force it past the 60° angle, as this will damage the unit.
USAGE
Make sure to leave the unit under direct sunlight for solar charging at least 10 hours. UNIT NEEDS TO BE FULLY CHARGED BEFORE INITIAL USE.
If there isn't ample sunlight, it may take longer for the batteries to charge.
- Turn the Solar Zapper on by pressing the ON/OFF button.
- Once dark outside, the UV light will turn on. It will attract the insects and draw them to the zapper grid. The high voltage will kill the insects.
- The floodlight part of the unit will turn on automatically (when dark) when it detects motion. The light will stay on for 30 seconds and then will go off if no motion has been detected.
- To turn the flood light and UV light off, press the ON/OFF button.
- The Solar Zapper and flood light will turn off during the day or if unit runs out of battery.
CLEANING
Keep your hands/fingers away from the zapper grid. Do not use water, liquids or sprays to clean.
- Make sure your Solar Zapper is turned OFF.
- Remove the cover from each of the zapper arms by twisting the cover off.
- Shake out dirt and debris or use a small soft brush (not included) to clean the grid.
- Place the cover back on, twist it to secure in place.
TROUBLESHOOTING
PROBLEM | CAUSE | SOLUTION |
UV light or flood light does not go on. | Not enough charge. | Make sure unit is installed where it can get maximum sun exposure for 10 hours. |
Unit is turned OFF. | Press the ON/OFF switch. | |
Unit is located near a strong light source. | Make sure unit is installed away from any strong light sources, such as an existing outdoor light. | |
Unit is placed under trees. | Move the unit to another open location. | |
Solar panel is dirty, or covered up. | Wipe the solar panel clean and make sure it is always free of debris. |
TECHNICAL INFORMATION
24SMD+8UV LED, 240LM
Solar panel: 5.5V 310mA
UV wavelength: 395nm
Grid Voltage: 1200V (on a fully charged battery)
Sensor distance: 3-5 meters
Sensor time: 30 seconds
Battery type: Built-in 2 x 1200mAh Lithium battery
Charge Time: approx. 10 hrs
IPX Rating: IP65
Documents / ResourcesDownload manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download BELL+HOWELL MONSTER SOLAR ZAPPER - 2 in 1 Flood Lights Bug Zapper Manual